These devices consist of four independent high-gain frequency-compensated operational amplifiers that are designed specifically to operate from a single supply over a wide range of voltages. Operation from split supplies also is possible if the difference between the two supplies is 3 V to 32 V (3 V to 26 V for the LM2902), and VCC is at least 1.5 V more positive than the input common-mode voltage. The low supply-current drain is independent of the magnitude of the supply voltage.

Features:

1. Wide supply voltage ranges
2. Low supply-current drain independent of supply voltage
3. Common-mode input voltage range includes ground, allowing direct sensing near ground
4. Low input bias and offset parameters
5. Internal frequency compensation
6. Common mode input voltage range includes ground, allowing direct sensing near ground
7. Input offset voltage is typical 3mV
8. Input offset current is typical 2nA
9. A differential input voltage range of 32V equal to the maximum rated supply voltage
10. Operating temperature range from 0°C to 70°C
11. Applications: Signal Processing, Consumer Electronics, Portable Devices, Sensing & Instrumentation, Motor Drive & Control, Test & Measurement

Note: Supply voltages larger than 32V for single supply and outside the range of ±16V for dual supply can permanently damage the IC

Warnings: This device has limited built-in ESD protection. The leads should be shorted together or device placed in conductive foam during storage or handling to prevent electrostatic damage to the MOS gates.